Smokecloak FL600 is an exclusively mixture of demineralised water and food grade glycols. The formula that has been developed through many years of experience and R&D and gives a unique combination of density and hang time.
The Smokecloak FL 600 fluid is very economical in use and requires just 0,45cc. to produce a cubic metre of Smokecloak vapour. The typical "hang"time in a static air environment is around 45 minutes and the FL 600 fluid creates a uniform sub micron particle size

Fluid is supplied in different sizes to suit the variety of machines and run times. The fluid is harmless and a full safety data sheet is available on request.

Product specifications:
* Dimensions 1 Litre: 13.5cm x 8.8cm x 17cm
* Dimensions 2.5 Litre: 15cm x 12cm x 23cm
* Weight 1 Litre: 1.25 kg
* Weight 2.5 Litre: 3 kg

The Smokecloak CS07 cloaksensor is the part of the system that detects whether the room has correct amount of vapour, and sends a signal to the Smokecloak machine requesting more vapour if the room is below the optimum level.

The unit is build into a standard smoke detector case and the internal circuitry and calibration is specifically designed and constructed to meet
the requirements of the Smokecloak system.

Product specifications:
* Weight: 0.167 kg
* Dimensions: 110mm x 50mm x 140mm
* Colour: White

The Smokecloak is installed with a lead acid battery insuring full smoke protection in the event of main power failure.

The battery is from one of the worlds leading manufactures of maintenance-free lead acid batteries. This assures long service intervals,
and low periodical costs.

The battery is especially designed for the operational conditions in alarm systems, with long stand-by periods and short intense energy loads.

Product specifications:
* Battery Type: NP2.1-12
* Nominal Voltage V: 12
* Capacity: 2.1 Ah
* Dimensions: 178mm x 34mm x 67mm
* Weight kg: 0.90